Welcome to the Trench Bases tutorial. Here I will take you on a Step-by-step trip through the process of creating the Trench Bases the same way as seen at: Gallery: Trench Crusade New Antioch.
Before we start, some notes:
For this tutorial I will be using:
Step one: Trench Floor
I started by breaking wooden coffee stirring sticks into small pieces, then gluing them on top of the bases about 1 mm apart from one another to leave some space to be filled with texture paste during the end stages. I then cut the excess of the sticks and filed it down with a sandpaper stick to match the base’s edge.
Step two: Rubble
Next I put small piles of gravel on the bases and poured thin super glue on top of them and in-between the ‘planks’. I then sealed it with short bursts of aerosol super glue activator. This created an irregular texture made of partially evaporated glue.
Step three: Charred Vegetation
I then broke a thin branch of dried out grape into small pieces and glued one piece on each of the larger bases.
Tip: I highly recommend sealing each piece with thin super glue for extra durability.
Step four [optional]: Barbed Wire
In order to make barbed wire I combined a curved screw and a screwdriver. I then rolled the twisted wire around a brush handle to form a proper shape. This was then cut into smaller pieces and glued on top of the bases.
Side note: For the New Antioch warband I used a ready to use product, but decided to include this DIY wire version in the basing tutorial. It’s not perfect, but it does the job and is much cheaper.
Step one: Base shading
With the modeling part complete I moved to the painting process. After applying black undercoat I airbrushed Vallejo 71.056 Panzer Dark Grey all over the bases. I then followed with Vallejo 71.044 Grey RLM02 airbrushed on top of rubble and branches.
Step two: Wood & drybrush
Next I covered planks and branches with The Army Painter Grim Black Speedpaint and left it to dry. Afterwards I drybrushed Vallejo 72.046 Ghost Grey all over the bases.
Step three: Barbed Wire base
I started the barbed wire with a layer of Vallejo 72.060 Tinny Tin.
Step four: Wash
I have covered everything with The Army Painter Strong Tone wash – Baron Harkonnen style (almost).
Step five: Barbed Wire
Once Wash dried out and done its job, I have applied a layer of Vallejo 72.609 Rust FX* to random spots on the barbed wire. I then flatbrushed a bit of Vallejo 72.052 Silver* on top and followed up with Vallejo 72.610 Galvanic Corrosion FX, again applied to random spots.
Side Note: *Vallejo Rust and Vallejo Silver are both optional. Looking back I do think I’ve unnecessarily overdone the barbed wire.
Step Six: Highlight
Next I added a bit of contrast by highlighting the sharp edges of the gravel piles, edges of the planks and a few spots on the branches with the Games Workshop Flayed One Flesh.
Step seven: Earth texture
Moving forward I applied a thick layer of AK Interactive Dark Earth texture prioritizing flat base surface, small space between the planks and some areas on top of gravel, to better set all these elements in the scene. The texture was then drybrushed softly with Games Workshop Karak Stone.
Finally I applied a few Gamers Grass Brown 2mm tufts here and there, thus finalizing the visual feel of the base.
I hope you find this review interesting. Be sure to let me know your thoughts in the comments below, or at Facebook or Instagram. I would also appreciate it if you considered sharing this content with your friends, who might find it useful. Finally if you are looking for a professional miniatures painting service, be sure to contact me with this contact form. I always reply within 24 hours, after which please check out your spam folder.